Table of Contents
Advertisement
Section 1 – Installation
Unpacking the Instrument
The following components are included with the complete 3260 system
• Mixer base
• Viton 1 Liter cup adapter
• Mixer drive shaft
• Mixer cup (1-Liter) with lid
Accessories supplied with instrument (check against accessory list inside the packing).
NOTE: Verify all parts listed on packing slip have been shipped with
Utilities Required
Model 3260-110V:
Model 3260-220V:
Tools/Equipment Required
None required
Setting up the Instrument
1.
Install the rubber adapter over the adapter shaft.
2.
Install the cup into the rubber adapter.
3.
Connect the power cord from the mixer base to an appropriately rated power source in
accordance with local wiring codes.
CAUTION: Wear hearing protective when using the mixer.
CAUTION: Check your power supply against your Model 3260 system
instrument. If parts are missing, contact Chandler Engineering.
120 VAC
230 VAC
power rating. Damage can occur if incorrect line voltage is
applied.
SECTION 1 – INSTALLATION
:
1-1
Advertisement
Table of Contents
