1.4.6 Environmental conditions / Intended Environment Warnings / Attention First application Scope of Supply Device Function Operation and Function Introduction Commissioning 3.2.1 Installation ri-sonic PCP-USB 3.2.2 Installation ri-sonic PCP-1 3.23 Auscultation Sessions (Examination of the patient) Care instructions General Information Cleaning and Disinfection Technical Data...
1. Introduction 1.1 Important Information read prior to Start-up You have purchased a high quality Riester Stethoscope, which has been manu- factured according to the Directive 93/42 EEC and is subject to the strictest qua- lity controls at all times. Read these instructions for use carefully before putting the unit into operation and keep them in a safe place.
Page 4
Manufacturing date YYYY-MM-DD / (Year-Month-Day) Manufacturer Lot number Relative Luftfeuchtigkeit für Transport- und Lagerbedingungen Air pressure for transport and storage Air pressure for Ambient Operating CE-Kennzeichnung 0124 Symbol for the marking of electrical and electronics devices according to Directive 2002/96/EC. Direct current Non-ionizing radiation USB- Plug...
1.3 Packaging Symbols Symbol Note on symbol Fragile. Show transport package contents fragile, so handling should be handled with care. Beware the package from getting wet. Upward. It shows the correct position to transport the package. Keep away from sunlight "Green Dot"...
Do not use, store or transport this product in excessively dusty conditions. There are no modifications to this product that a user can make and they should not attempt to do so. If a unit fails to perform properly, contact Riester Repre- sentative from which the unit was purchased for service.
Art.Nr. 4310 ri-sonic PCP-1 - Instruction of use a stetho- 2.2 Device Function ri-sonic PCP-USB connector with straight cable d person onment. ri-sonic PCP-1 with spiral cable nesthetic y should Chest Piece Top r Repre- c PCP-1...
3. Operation and Function 3.1 Introduction The ri-sonic PCP-USB / ri-sonic PCP-1 chestpiece can be used with a general The device / PC that supplies power must comply with IEC 60950. ri-sonic PCP-USB The ri-sonic PCP-USB stethoscope is intended for use with a standard PC, mobi- le devices (with USB port) and appropriate app or software, which is not included.
Page 9
PCBA is obtained from the 5vdc lead of the USB interface to the PC to which the ri-sonic PCP-USB is connected during service. The block dia- gram for the circuitry on the PCBA is shown in the following figure.
Installation of the ri-sonic PCP-USB Stethoscope is comprised of plugging the USB connector of the ri-sonic PCP-USB Chest Piece into the USB port of the PC. For usage with PC only no additional software ist required. For use with speciali- zed software follow the instructions of the Software.
PC. speciali- The ri-sonic PCP-USB / ri-sonic PCP-1 Chest Piece is not a sterile device and does not require sterilization Do never put stethoscopes into liquids! ging the one port...
Art.No.75042 Instructions of use ri-sonic PCP-USB / ri-sonic PCP-1 Stethoscope 7. Maintenance / Accuracy check / Calibration The ri-sonic PCP-USB / ri-sonic PCP-1 Chest Piece requires no preventive in- spection, no preventive or routine maintenance, and it does not have to be ca-...
9. Trouble Shooting If no stethoscope sounds are heard from the PC: re up to Check for a failed ri-sonic PCP-USB / ri-sonic PCP-1 Chest Piece by testing the local loop back through the PC Control Panel er vapor range Check for a failed ri-sonic PCP-USB / ri-sonic PCP-1 Chest Piece by substituting it with a replacement ri-sonic PCP-USB / ri-sonic PCP-1 Chest Piece.
Page 14
Failure to comply may result in a reduction in the device‘s performance features. Directives and manufacturer‘s declaration - Electromagnetic emissions The Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 are intended for use in the electromagnetic environ¬ment specified below. The customer or user of the Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 should ensure that it is used in such an environment.
Page 15
The Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 intended for use in the electromagnetic environment specified below. The customer of medical the user of the Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 netic en- should assure that it is used in such an environment.
Page 16
The Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 is intended for use in the electromagnetic environment specified below. The customer or the user of the Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP- 1 should assure that it is used in such an environment.
Page 17
Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 is used exceeds the applicable RF compliance le- vel above, the Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 should be observed to verify normal operation. If abnormal performance is...
Page 18
PCP-USB / ri-sonic PCP-1 can help prevent electromagnetic inter- ference by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the Electronic Stethoscopes ri-sonic PCP-USB / ri-sonic PCP-1 as recommended below, according to the maximum output power of the communications equipment. Rated maxi-...
You are also welcome to request a provisional cost estimate from us free of charge. In case of a warranty claim or repair, please return the Riester product with the completed warranty Card to the following address: Rudolf Riester GmbH Dept.
Need help?
Do you have a question about the ri-sonic PCP-USB and is the answer not in the manual?
Questions and answers