Behringer X32 User Manual page 51

51
X32 COMPACT DIGITAL MIXER User Manual
7.4.4 Routing Screen: P16 Tab
The routing screen's P16 tab allows the user to route various console signal paths
to the rear panel P16 Ultranet output. The Ultranet output allows for 16 channels
of audio to be sent, in digital form, to various accessories such as a personal
monitoring distribution box.
Using the P16 routing screen, the user can con gure the P16 output to carry not
only the main LR mix, but also various audio "stems" of program material sources
from a bus send mix, such as a stereo drum mix, stereo keyboards, guitars,
bass, vocals, etc. Musicians on stage would then be free to each craft their own
personal mix of these musical stems, all delivered from the FOH position to stage
over a single Ethernet cable.
To select which audio signals are sent to the P16 bus, perform the following steps:
1. Adjust the 1st encoder to select which of the 16 channels in the P16 bus you
wish to select an audio source for.
2. Adjust the 3rd encoder to select a category of audio source to send to the
currently selected P16 channel. These categories include:
Insert
Main (LRC)
Mix Bus
Matrix
Direct Out
Monitor
3. Adjust the 4th encoder to select which speci c signal path to feed to the
currently selected P16 output. Choices include:
O
Main L
Main R
Main C/M
Any of the 16 Mix Outputs
Any of the 6 matrix outputs
Any of the 32 direct outputs
Any of the 8 Auxiliary Outputs
Any of the FX Direct Outputs
Monitor L
Monitor R
Talkback
4. Tap the 4th encoder to assign the selected output path,
completing the process.
5. Adjust the 5th encoder to select the signal tap point for the output assignment.
This determines where in the audio signal path the source is "tapped" as it is
sent to the P16 output. The available signal tap points include:
Input
Pre-EQ
Pre-Fader
Post-Fader
6. Tap the 5th encoder to complete the signal tap point assignment.
7. Tap the 6th encoder to enter iQ Setup
Adjust the 1st encoder to select a P16 channel.
Adjust the 3rd encoder to select the iQ speaker assigned to the selected
channel. Press the encoder to con rm.
Adjust the 4th encoder to select an EQ Preset, then press the encoder
to con rm.
Adjust the 5th encoder to select a Sound Pro le that the iQ speaker will
model, then press the encoder to con rm.
Press the 6th encoder again to return to the P16 tab.