Behringer X32 User Manual page 35

35
X32 COMPACT DIGITAL MIXER User Manual
32 in / 32 out
This mode obviously allows the full potential of the interface to be tapped.
Note that the computer needs to be able to handle that amount of concurrent I/O
stream without any glitches. Depending on its speed and memory con guration,
some optimization for audio recording might be required.
Generally, the Card outputs may use any of the available signal sources in the
console (local or AES50) for recording independently. When the X32 COMPACT
is used in a quasi in-line mode, the card with connected computer represents a
classic tape machine. In this case, the X32 COMPACT mic inputs would be selected
to feed the card outputs (see graphic), and all signals are run from the mixer's
preamps directly to the multi-track recording machine (PC) and from there 1:1
back into the console's input channels.
When the console channel inputs are set to Card, the channel Gain control will be a
+/- 12 dB digital trim for the interface card signal, without direct access to any head
amp - which is great for mixdown but would be an issue for recording. So, mixing
and monitoring can be done using the X32 COMPACT input channel controls, but the
It is also possible to run a virtual sound check of all 32 input channels by recording
them directly to a computer during a brief line check. The performers can leave
the stage while you play back the recorded instruments from the hard drive and
tweak the sound accordingly.
actual mic preamps must now be controlled from the Setup/preamps page, which
gives remote control to every one of the available preamps in the system. Use the
Setup/preamps page to make sure that phantom power is set as needed, and that
there is a reasonable amount of headroom for recording the preamp signals.
TIP: Sometimes it is more convenient to run the sound check while the preamps
are still connected to the X32 COMPACT input channels. Once you are con dent
about the fundamental settings, you can switch the channel inputs to the X-USB
Card inputs for laying the tracks and monitoring the DAW outputs.
If you wish to switch back and forth between the two modes more frequently,
you could consider storing 2 routing scenes, 'DAW' and 'preamps'. Make sure
Scene Safes are set in a way that all other parameters remain unchanged.