Behringer X32 User Manual page 50

50
X32 COMPACT DIGITAL MIXER User Manual
7.4.3 Routing Screen: Aux Out Tab
The route screen's aux out tab allows the user to patch an internal signal
path (such as a mix output used as an e ects send) to the 6 separate ¼"/RCA
auxiliary outputs.
Since these six outputs can have a wide variety of signal paths assigned to them,
they can be used for a wide variety of tasks, such as:
1. Feeding an external e ects processor when the internal e ects
are insu cient
2. Patching a speci c console signal path into an outboard recorder
3. Feeding the analog or digital audio inputs of a nearby video recorder
To make an assignment as described above, perform the following steps:
4. Adjust the 1st encoder to select which auxiliary outputs to assign a source
for. Choices include:
Aux Out 1
Aux Out 2
Aux Out 3
Aux Out 4
Aux Out 5
Aux Out 6
AES/EBU (Digital) Out L
AES/EBU (Digital) Out R
5. Adjust the 3rd encoder to select for coarse range
Insert
Main (LRC)
Mix Bus
Matrix
Direct Out
Monitor
6. Adjust 4th encoder to select speci c signal path to feed the selected physical
output. Choices include:
Insert Point
Main L
Main R
Main C/M
Any of the 16 Mix Outputs
Any of the 6 matrix outputs
Any of the 32 direct outputs
Any of the 8 Auxiliary Outputs
Any of the FX Direct Outputs
Monitor L
Monitor R
Talkback
7. Tap the 4th encoder to assign the selected output path,
completing the process.
8. Adjust the 5th encoder to select the signal tap point for the output
assignment. Choices include:
Input
Pre-EQ
Pre-Fader
Post-Fader
9. Tap the 5th encoder to complete the signal tap point assignment.