Advertisement
Available languages
Available languages
Troubleshooting Guide
Problem
The processor will not operate.
Blender or mill will not operate
Processor stops during
processing
Blender, or mini chopper/mill
leaking from blade assembly
base.
Poor performance of tools/
attachments
5722000073 Iss 1 Braun Metal FP301BI.Eng_Ara B5.indd 8
5722000073 Iss 1 Braun Metal FP301BI.Eng_Ara B5.indd 8
Cause
No Power.
Bowl not fitted to power unit
correctly.
Bowl lid not locked on correctly.
Blender or mill not locked on
correctly.
Blender or mill not assembled
correctly.
Processor overloaded/maximum
capacities exceeded.
Lid unlocked.
Seal missing
Seal incorrectly fitted
Seal damaged.
Refer to hints in relevant 'using the attachment' section. Check attachments are
assembled correctly.
8
Solution
Check processor is plugged in.
Check that the feed tube and bowl handle are
situated to the right hand side.
Check that the lid interlock is located
correctly into the handle area.
The processor will not work if the bowl
and lid are fitted incorrectly.
Blender or mill will not operate if fitted
incorrectly to the interlock.
Check blade assembly is fully tightened into
the goblet/jar
Check maximum capacities stated in the
recommended usage chart.
Check lid is locked correctly.
Check seal is fitted correctly and not
damaged. To obtain a replacement seal see
'service and customer care'.
06/02/2020 08:24
06/02/2020 08:24
Advertisement
