Setting The Security Code; Operation - NexxTech 4908422 Owner's Manual

Setting the Security Code

You can set your own four-digit security
code.
Notes:
• Your alarm's security code is preset
to 1234 at the factory. We recom-
mend you use a different security
code.
• You must enter all four numbers
within 15 seconds, or the red indica-
tor turns off and the alarm exits the
procedure and resets to the previous
security code.
• If you remove the battery, the secu-
rity code resets to 1234.
Follow these steps to set your own secu-
rity code.
1. Press . The red indicator lights.
CODE
illustration
2. Enter the current security code. The
red indicator flashes.
3. Enter the desired four-digit code. The
red indicator lights steadily.
4. Press within 5 seconds to
CODE
store the code. The red indicator
turns off.
Note: If you do not press
within 5 seconds, the red indicator
turns off and the alarm exits the pro-
cedure and resets to the previous
security code. Start over at Step 1.
Checking the Security Code
Follow these steps to check your security
code.
1. Set the slide switch to Delay and
open the door.
2. Enter the security code within 8 sec-
onds. The red indicator lights briefly.
If the indicator does not light or the
alarm sounds, you entered the wrong
security code. Remove and reinstall
the battery to reset the code to 1234,
then change the code again.

OPERATION

You can set the alarm to announce visi-
tors, alert you to intruders, or sound a
panic alarm, or you can turn it off.
CODE
4
illustration