NexxTech 4908422 Owner's Manual page 4

Use the supplied screws or the supplied
adhesive tape and follow these steps to
mount the alarm and magnet.
1. If you are mounting the alarm using
the supplied screws, remove the two
screws on the bottom of the alarm
and remove the back cover.
illustration
2. Use three of the five supplied long
screws or the two larger pieces of the
supplied adhesive tape to mount the
back cover.
illustration
Note: If you need to drill starter holes
for the screws, use the back cover as
a template.
3. Slide the alarm onto the mounted
back cover.
illustration
4. Replace the two screws on the bot-
tom of the alarm.
5. Use the two remaining long screws
or the smaller pieces of the supplied
adhesive tape to mount the magnet
so its arrow points toward one of the
markings on either side of the alarm.
illustration
To check the installation, set the alarm's
slide switch to Chime and open the door.
You should hear the electronic chimes. If
you do not, readjust the position of the
magnet.
illustration
3