Table of Contents
Advertisement
3. Put your fingers into the holes on the
back cover and lift to remove the
cover.
illustration
4. Snap the battery connector over the
battery's terminals.
illustration
Note: If the alarm sounds, enter the
preset factory security code, 1234, to
silence it (see "Setting the Security
Code" on Page 4).
5. Replace the cover, then reinsert and
tighten the screws.
Replace the battery when any of the fol-
lowing occurs:
• the
chimes'
or
becomes weak
• the red indicator does not light
• the alarm does not work at all when
the door opens
• the alarm sounds a steady tone, and
you cannot stop it by entering the
security code
If the alarm does not respond after you
replace the battery, remove the battery
and reinstall it. Each time you remove the
battery, the security code resets to 1234.
Cautions:
Installing the Alarm
For proper alignment, you must mount
the alarm and magnet so the magnet
rests with its arrow pointing toward one of
the alarm's markings. Choose a location
that lets you install the magnet on a door
or window and the alarm immediately
next to it on the frame, or vice versa. The
distance between the alarm and magnet
must be no more than
alarm's
sound
here).
2
• the alarm stops sounding before you
enter the code or before 90 seconds
pass
• Always remove an old or weak bat-
tery. Batteries can leak chemicals
that can destroy electronic parts.
• Dispose of the old battery promptly
and properly. Do not burn or bury
them.
5
/
illustration
inch (as shown
16
Advertisement
Table of Contents
