Aufbauanleitung / assembly instructions mod.
3453 - 3455
1x
SW17
8x
29,5 x 10,5
8x
M10
1. Montagematerial
1. fitting material
3. Die Unterbau-Wangen auspacken.
Die Bolzen in die Muffen der Wangen
schrauben. Die Bolzenlöcher in Richtung der
Zargen ausrichten.
3. Unpack the table-base legs.
Screw the bolts into the threaded sleeves. The
holes of the bolts must fall in a line.
3453 - 3455
8x M10 x 610
4x
1 / 3
2. Den Oberbau auspacken und auf zwei
gepolsterte Montageböcke legen.
Die Unterbau Zarge entnehmen.
2. Put the table-top upside down onto padded
assembling trestles.
Take the wooden shroud out of the table-base.
4. Die Verbinder-Muffen in die Zarge stecken. Die
Löcher der Verbinder-Muffen in die Richtung
der Zarge ausrichten. Die Zarge auf die Bolzen
stecken. Mit den Verbinder-Schrauben die
Zarge fixieren.
Die zweite Wange ebenso montieren.
4. Stick the threaded sleeves into the shroud. The
holes of the threaded sleeves and the holes of
the shroud must fall in a line. Stick the shroud
onto the bolts. Turn in two screws.
Fix the the other side in the same way.
Änderungsdatum: 09.11.15