Hisense RF200D4CSE User's Operation Manual page 7

Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
tool.
To allow the doors to self-close, tilt the
top backwards by
0.4" - 0.6"(10 -15mm)
Adjustable
A
bottom feet
Front roller
B
Rear roller
C
A B
.
0.4" - 0.6"(10 -15mm)
C
Adjustable
bottom feet
Door Removal
In case your home access door is too
narrow for the refrigerator to pass
through, remove the refrigerator doors
and drawers. If you do not need to
remove the appliance doors, proceed
to "Installing Water Lines" on page 9.
If you need to remove the doors,
continue below.
Tools you will need(Not provided)
Allen Wrench (5/32",4mm)
Philips Screwdriver
WARNING!
Electrical Shock Hazard
Disconnect power before removing doors.
Reconnect ground wire before operating.
Failure to do so could result in death or
electric shock.
IMPORTANT: Keep the refrigerator doors closed
until you are ready to lift them from the cabinet.
1. Unplug refrigerator or disconnect power.
2. Using a Phillips screwdriver, remove the three
screws(A) attaching the hinge cover, and then
remove the hinge cover with the entire
harnesses attached.
Wrench (5/16",8mm)
7