Table of Contents
Advertisement
Available languages
Available languages
- Usage:
When the device is on, the R2(10A) relay output is activated by keeping the start button
pressed. The relay output time is as long as the time set on the timer screen. Pressing
the stop button stops the time. R1(30A) relay output becomes active according to the set
degree set on the temperature screen. When it reaches the set point, the R1 relay stops
giving output.
When you start the device for the first time, an odor and smoke may occur due to insulation
material and heating elements. Therefore, before starting to use, set all thermostats to
maximum and run the device idle for 30 minutes. After 30 minutes, let the device cool down.
Make sure that the surfaces that will come into contact with food are clean.
Pour the mortar prepared for the waffle in an amount that will not overflow from the mold.
Spread the mortar on the mold with a spatula. Close the top lid on the mortar and cook.
-Service Menu;
-When the device is off, the service menu is accessed by pressing and holding the
button for 5 seconds.
-When in the service menu, it is possible to switch between parameters with the help of
the
adjusted with the help of
-Press the
button to exit by saving.
Parameter
PCB temperature
Temperature Display Unit
Thermocouple Type
Maximum Set Temperature
Maximum To Be
buttons next to the temperature screen. Parameter value range is
button to exit without saving the change in the parameter menu, and the
Explanation
Hysteresis
Selection
to be Adjusted
Adjusted
Time
Table 1: Service Parameters
buttons next to the time display.
Min Value Max Value
−
−
24
Unit
Factory settings
−
−
−
Minute
Advertisement
Table of Contents
