External Device Connection - Telefunken TF-PS2304 Instruction Manual

External device connection

• You can connect the audio output of an
external device to this unit, to listen to the sound
of that device through the speaker.
• To connect an external audio device,
please use an audio cable with 3.5mm-to-3.5
mm plugs to connect the headphone out or
audio line-out of the external device to the
AUX input of this unit.
• Press MODE button to select the AUX mode.
• Turn on the external device. You can
press the volume buttons on the RC to adjust
volume.
USB/MicroSD operation
Playback
•
Turn on the device.
• Insert a microSD (TF) card into the slot.
Or insert a USB drive into the USB
port. Press the MODE button repeatedly to
select the USB or MicroSD mode.
• When playing, you can press
to play/pause the playback.
• During the playback you can press
the and buttons to go to the previous
and next track. Rotate the volume indicator
to adjust volume.
It may take up to 60 seconds to open
and verify a large microSD card / USB drive
with many files.
• Press the EQ button to switch
between various equalizer presets. EQ is
only available in the BT and USB/TF
modes.
General USB/MicroSD notes
• This unit is equipped with a microSD slot
and USB port that can read and play MP3
files stored on standard microSD cards and
USB drives up to 32 GB.
Instruction Manual
• FAT and FAT32 file system is supported
by this unit.
Never remove microSD cards and USB
drives from the unit during playback, always
stop playback, then press the MODE button
to switch to another mode before removing
the storage to prevent damage to your files
and cards/drives themselves.
If there is a microSD card or USB
drive installed in the unit, when powered
on, playback will automatically start
from microSD/USB.
Slight noise during playback pauses
is not a construction defect, it is
determined by the factory presets of the
dynamic noise reduction system.
FM radio
• Turn on the device.
• Press the MODE button
repeatedly to select the FM mode.
• Press and hold
scan and save all available radio
stations. The procedure will take
several minutes and cannot be
interrupted.
• Radio frequency can be set
manually using the numeric buttons on
the remote control.
• Once the search is finished, you can
press the and buttons to go to a
previous or next radio station. Also you
can input the frequency directly using
the numeric buttons on the remote.
to automatically
4