Chapter 9: Maintenance - Epson DX5 X 2 Calibration And Maintenance

Chapter Chapter
Chapter Chapter
9. 9. 9. 9. Maintenance Maintenance Maintenance Maintenance
9.1 9.1 Normal Normal Cleaning Cleaning
9.1 9.1 Normal Normal Cleaning Cleaning
Click Clean on the main interface of the software. There are two modes of cleaning, Normal
different combination.
9.2 9.2 9.2 Cleaning 9.2 Cleaning Cleaning Cleaning procedures procedures for procedures procedures
1. Disconnect the tube connector for the tube from cartridge to the damper. Choose Standard clean mode the
suck out the ink in the damper. (2 times)
2. Use an extend tube to connect the damper, put the other side of the extend tube into the appointed Flush.
Choose Depth clean mode to clean the damper and the printhead at the same time.(3 times)
3. Take out the extend tube from the Flush, and keep it out in the air. Choose Depth clean mode to suck out the
Flush inside the damper and the printhead. After that connect the damper to the ink incoming tube and fill ink
again.
4. Test print.
9.3 9.3 9.3 9.3 Carriage Carriage Carriage Carriage Bearing Bearing Bearing Bearing and
Due to the carriage slides on four steel plates and eight bearing, clean and lubricate four steel plates with grease
everyday.
Ⅰ. Wipe a thin layer of grease on steel plates to maintain cleanliness and grease everyday before and after
usage.
Ⅱ. Be aware of the smoothness of the carriage bearing
All manuals and user guides at all-guides.com
for for for nozzle nozzle nozzle nozzle clogging: clogging: clogging: clogging:
and and and Steel Steel Steel Steel Rail Rail Rail Rail Maintenance Maintenance Maintenance Maintenance
19
Normal and Strong Normal Normal Strong for Strong Strong