Note: Notes have important information and useful tips on the operation of your display. EPSON is registered trademark of Seiko Epson Corporation. Contents Unpacking ............. . . 3 Cautions on Handling .
If you find anything missing or damaged, please contact your DP-505 dealer. Cautions on Handling When you use the DP-505, be sure to note the following points: Avoid locations that are unstable or are subject to high levels of vibration.
Assembling Before assembling this product, you must install the UB-S09 in the TM printer. See the UB-S09 installation manual for installation steps. Assembling steps using Velcro tapes 1. Make sure both the printer and the host computer are turned off. 2.
Page 5
4. Pass the cable for the display through the hole on the fixing plate and attach the support to the fixing plate as shown below. 5. Peel the backing off of one side of the Velcro tapes and attach the tapes to both faces of the fixing plate.
Page 6
6. Peel off the backing on the other side of the Velcro tapes, and stick the fixing plate where you want it to be. 7. Connect the cable for the display to the DC connector on the TM printer (UB-S09) until you feel it click. Store any excess cable in the TM printer, if necessary.
Page 7
8. Place the TM printer on the fixing plate. Since the forms of the rear side of the printer are different, see the table below for the mounting position for each TM printer.) Printer type Mounting positions for TM printers TM-T88II Set the printer so that no rubber foot on the rear side of the printer is placed on the Velcro tape.
Assembling steps using screws 1. Follow steps 1 to 4 in “Assembling steps using Velcro tapes.” 2. Secure the fixing plate where you want it with the fixing screws. 3. Follow steps 7 to 9 in “Assembling steps using Velcro tapes.” General Specifications 260 mm {10.2 in.}...