Adjusting Or Deactivating The Filter Saturation Indicator For The Charcoal Filter; Deactivating Power Management - Miele DAS 4930 Operating And Installation Instructions

Adjusting or deactivating the
filter saturation indicator for
the charcoal filter
Charcoal filters are needed for
recirculation mode.
The filter saturation indicator can be set
to suit the customer's cooking habits.
It has to be deactivated for extraction
mode.
The factory default setting is an interval
of 180 hours.
 Touch the On/Off switch .
All symbols light up with reduced
brightness.
 Press and hold the delayed shutdown
control  until the grease filter 
and charcoal filter  symbols light
up.
 Touch the charcoal filter symbol .
The charcoal filter symbol  and one of
the blower power level indicators will
flash.
The indicators 1 to B show the current
time setting:
1............................................. 120 hours
2............................................. 180 hours
3............................................. 240 hours
Indicator B .......................... deactivated
 Touch the relevant digits to select the
desired duration.
 Confirm your choice by touching the
charcoal filter control . If the
selection is not confirmed within
4 minutes, the system will revert to
the previous setting.
Changing settings
Deactivating power
management
Keep in mind that this may increase
energy consumption.
Activating/deactivating power
management
 Touch the On/Off switch .
All symbols light up with reduced
brightness.
 Press and hold the delayed shutdown
control .
After a few seconds, the grease filter 
and charcoal filter  symbols light up,
and after a further 5 seconds the 1
blower power level indicator lights up.
 Then press in order:
- the lighting control ,
- the 1 control, and then
- the lighting control .
When power management is turned on,
the 1 and B indicators will be
continuously lit.
When it is turned off, the 1 and B
indicators will flash.
 Touch the 1 control to deactivate
power management.
The 1 and B indicators will flash.
 Touch the B control to activate power
management.
The 1 and B indicators will be
continuously lit.
 Confirm the setting by pressing the
delayed shutdown control .
All the indicator lights will go out.
25