2 .
2 . 2 .
2 .
I D E c o n n e c t o r s ( 4 0 - 1 p i n I D E 1 , I D E 2 )
I D E c o n n e c t o r s ( 4 0 - 1 p i n I D E 1 , I D E 2 )
I D E c o n n e c t o r s ( 4 0 - 1 p i n I D E 1 , I D E 2 )
2 .
I D E c o n n e c t o r s ( 4 0 - 1 p i n I D E 1 , I D E 2 )
I D E c o n n e c t o r s ( 4 0 - 1 p i n I D E 1 , I D E 2 )
These connectors are for an Ultra DMA 100/66 signal cable. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector for
an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),
and a gray connector for an Ultra DMA 100/66 IDE master device (hard
disk drive). If you install two hard disk drives, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer
to the hard disk documentation for the jumper settings.
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
A8NE-FM
®
A8NE-FM IDE connectors
A S U S A 8 N E - F M
A S U S A 8 N E - F M
A S U S A 8 N E - F M
A S U S A 8 N E - F M
A S U S A 8 N E - F M
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
1 - 2 3
1 - 2 3
1 - 2 3
1 - 2 3
1 - 2 3