Table of Contents
Advertisement
Mixing Process
1. Plug the appliance into a suitable single socket.
2. Switch the appliance on by setting the ON/OFF switch in 'I' (ON) position.
WARNING!
Hold the mixing beaker firmly by the handle during mixing.
3. Use the RPM controller to select the right speed in the range of 'MIN' to 'MAX'.
Rotate the controller clockwise to increase speed or anti-clockwise to reduce it.
The appliance processes the ingredients very quickly.
4. Observe the mixing process.
5. After mixing, switch the appliance off and check the consistence of the mixed
ingredient.
6. If needed, switch the appliance back on after cooling off.
7. After each mixing wait for the appliance to cool down in order to prevent
overheating due to too long an operation.
8. When ingredients are supposed to be mixed shortly, use the PULSE function
with the appropriate pulse operation switch.
EN
This function makes the motor operating at the maximum speed when the switch is
on.
9. If needed, you may use the opening in the lid to add subsequent ingredients
during operation; to this end, remove the transparent lid plug.
10. If needed, use the enclosed pusher to move the added ingredients towards the
knife.
The pusher is designed in such way that it does not touch the knife at the beaker
bottom.
11. Close the lid again with the plug.
12. Do not process too much of solid or hard products in one batch. For better
results process them in smaller amounts.
13. If the knife is blocked, and the motor starts to seize, proceed in the following
way:
– switch the appliance off immediately,
– disconnect the plug from the socket,
– remove some of the ingredients from the mixing beaker,
– mix the ingredients manually in the mixing beaker,
– continue with mixing by pressing the ON/OFF switch.
16 / 22
Installation and operation
150159
Advertisement
Table of Contents
