KNOVA KN RO-1304 Manual page 6

APPLICATIONS
4) Hold the trimmer closely to operate the trimmer in a
circle as defined by the screw as follow.
Line guide
4. USING THE BASE GUIDE
1) Loosen the clip knob A to install the base guide on
the base plate of the trimmer.
2) Loosen the clip knob B and adjusting knob to get
the desired distance between the base guide and
milling cutter.
3) Tighten clip knob B to secure the base guide in place.
4) Hold the trimmer firmly as below.
Nail
Center
point
5) During cutting, make sure the rubber block on base
guide keep flush and advancing smoothly along
the edge of work piece.
Adjusting screw
Milling cutter
Work
piece
Trimming guide
Trimming guide
Tight screw A
Tight screw B
Block