KNOVA KN RO-1304 Manual page 5

APPLICATIONS
2. USING THE PARALLEL GUIDE
The parallel guide is an effective aid to cutting in a straight
line when chamfering or grooving.
1) Discharge the base guide.
2) Assembly the straight guide with extension guide with
screw, washer and nut as follow.
Square neck bolt
Guide
Line guide
Washer
Spring washer
Wing nut
3) Loosen the clip knob and tighten it to lock the
extension guide as follow . This will assist in keeping
the guide flush with the side of the work piece.
4) Loosen the string nut and adjusting distance between
straight guide and milling cutter until it is at the desired
distance.
5) Tighten the string nut to hold it in position.
NOTE: If the distance between the side of the work
piece and the cutting position is too wide, or the side of
the work piece is not straight, firmly clamp a straight
board to the work piece and use it as a guide against
the trimmer base.
3. USING THE CENTRE LOCALIZER
1) Assembly the straight guide with extension guide as
follow.
Center point
2) Mark the centre point of the circle on the work piece,
and align the centre hole with the cut centre point, and
then fix a screw (diameter less than 6mm) into it to
keep them stable.
3) Adjust the cutting diameter by adjusting the connection
and direction of straight guide and extension guide.
• Cutting radius: 70-155mm as below.
• Cutting radius: 103-221 mm as below
Wing nut
Spring washer
Washer
Line guide
Guide
Square
neck bolt