Table of Contents
Advertisement
6.2 Upgrade using IrDA Cable
1.
Connect power to equipment
2.
In the menu go to, Setup->"password"->Communication-> Firmware upgrade by Infrared-
>Confirm Firmware upgrade and press "OK"
3.
Display should now be looking like this:
Upgrade Ready
Power Cycle and
Start PC App.
4.
Turn Off equipment and turn it on again (Power cycle)
5.
Make sure the All three led's are on (Green "ON", red "ERROR" and red "OFF") and the
display is blank
6.
Connect Irda module (Item No. 110001558) to PC USB port
7.
Place Irda module on display module like this
8.
Startup PC program FWU200.exe (can be downloaded from Nilfisk Food website)
9.
Window should be looking like this
10.
Press "Browse" button
11.
Select the file you will use for upgrade. Software File can be downloaded from Nilfisk Food
website. The name of the file should end with ".hex". Ex V4.14_SB_DISP.hex
110007944-EN
Software Manual_Pegasus.
16
Advertisement
Table of Contents
