Content Of The Setup Menu - Nilfisk-Advance MD421-P Software Manual

1. Signal from block sensor, out of range
C34 High Sensor
Signal block
1. Signal from flow sensor, out of range
C35 High Sensor
Signal flow
C40 Sensor Load 1. Supply voltage for pumptop sensor too low.
Pumptop Sensor 2. Pumptop sensor using too much current
C41 Sensor Load 1. Supply voltage for inlet sensor too low
Inlet sensor 2. Inlet sensor using too much current
C42 Sensor Load 1. Supply voltage for block sensor too low
Block sensor 2. Block sensor using too much current
1. Supply voltage for flow sensor too low
C43 Sensor Load
Flow sensor 2. Flow sensor using too much current
C45 Inverter 1. Water consumption too high
Module temp. 2. Ambient temperature too high"
C46 Inverter 1. Water consumption too high
Board temp." 2. Ambient temperature too high
3. Load at Board high"

5.3 Content of the Setup menu

The Setup Main menu contains the below submenus, which will be described subsequently.
C
Setup
Password Note: Default user password is 6802. Enter the settings menu
to change the default password. To avoid unintended access to the system
the Local service technician can insert a blocking preventing access to the
password controlled menus.
110007944-EN
Software Manual_Pegasus.
CA
Password
0000
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Press "off" button
2. If error reoccurs, contact your local
service technician.
1. Lower the load for inverter
2. Lower the ambient temperature"
1. Lower the load for inverter
2. Lower the ambient temperature
3. lower the load at board"
E
Settings
S
F
Languages &
L
units
I
Communication
PC
K
Installation
11