Table of Contents
Advertisement
O
O
rd
d
e
e
r
of
Pre-Day
*Put a 1.75 liter or bigger container under the hot water dispense tube,
lock grounds chamber in place, and press reset for three seconds. Any
extra/remaining water will evacuate through the hot water dispense tube.
Once there is confi rmation that the tank is clear start an empty 1.5 liter
batch on the coffee side to preheat the unit. Make sure that the grounds
chamber is securely attached by angling the handle half-way between the
airpot hanger receptacle and the lever slot for the grounds chamber lever,
then lifting the grounds chamber into a locked position by pulling the
grounds chamber lever towards the front of Bravura Press.
Brewing Operations
1. Confi rm that no liquid is in brew chamber by lifting lid to peer inside.
2. If liquid remains in brew chamber, follow dispense instructions until
liquid is below the dispense hole located on the inner wall of the
grounds chamber, remove grounds chamber and dump the liquid.
3. If brew chamber is free from liquid and the grounds chamber
is clean and clear of any contents, then push the grounds chamber
lever to the rear position to lower the grounds chamber If choosing to
use the compostable liner, place liner on top of the grounds chamber
and using both hands press the liner to the bottom of the inside of the
grounds chamber so that the fanned edges hug the inside wall.
4. Fill the inside of the grounds chamber with ground coffee, preferably a
french press grind setting: 1.5 cups for a 1.5 L pot, 3 cups for a 3.0 L
pot. Overfi lling grounds past the 3 cup volume can lead to grounds in
the coffee, or even the inability to dispense.
5. Place grounds chamber in position under brew chamber, align handle
half-way between the airpot hanger receptacle and the front of the
lever slot for the grounds chamber lever.
6. You will know the grounds chamber is positioned in the proper center
position because you will feel the subtle placement of a nipple and
receiver on the bottom of the grounds chamber.
7. Once in position, pull the grounds chamber lever towards the front of
Bravura Press until it locks in place.
8. Attach a clean screen wiper onto the bottom of the press stem by fi tting
the key at the end of the stem into the key hole on the top of the
screen wiper, then turning the brew stem handle 180° until it latches.
9
Op
p
er
r
ations
Advertisement
Table of Contents
