Codes And Standards; Assembly - Bravura A-1020 Installation & Operational & Instructions Manual

Coffee press
Table of Contents

Advertisement

Codes and Standards

The Bravura Press must be installed in accordance with:
In the United States: State and local codes, or in the absence of local
codes, with: National Electrical Code, ANSI/NFPA-70 (or latest edition).
Copies may be obtained from The National Fire Protection Association,
Batterymarch Park, Quincy, MA 02169-7471.
In Canada: local codes CSA C22.1 Canadian Electric Code L4W 5N6.

Assembly

Install on a level surface. The bottom support feet are levelers. They
can be adjusted by spinning them to the proper height.
Notice: Bravura Press will warn of error states and pause the cycles
if the unit is not level. (see pg. 14 for error states)
Notice: Do not remove the control panel or your warranty will be void.
After leveling unit on counter, attach screen wiper to brew stem by
inserting bottom of the stem into the keyhole on the top of the screen
wiper and turn top handle 180 degrees to lock into place.
• The grounds chamber can be attached by placing it underneath
the brew chamber when grounds chamber lever is in the rear position.
Handle of grounds chamber should be set half-way between the airpot
hanger receptacle and the grounds chamber lever.
• Lock grounds chamber into brewing position by pulling grounds
chamber lever to the front of Bravura Press.
• The water gauge on the back of the unit on the water line should be
set between 25-30.
Notice: Removable grounds chamber should be in locked position at all
times except to extract the spent grounds after the hot liquid has been
dispensed.
Electrical Connection Warnings
• Warning - electrical and grounding connections must comply with the
national electrical code and/or other local codes.
• Warning - do not remove or damage any grounding prongs or
receptacles. If the receptacle is not the proper grounding type, contact
a licensed electrician.
• Warning - the servicing agent must disconnect the electrical
connection before removing the rear encasement.
• Warning - only plug the L14-30 plug into the proper corresponding
L14-30 outlet.
7

Advertisement

Table of Contents
loading

Table of Contents