Sym MIO ELECTRIC Manual page 18

Checking front brake lining

Check the brake from behind the brake caliper.
The brake pad must be replaced with new
lining when the brake pad wear limit reaches
the brake disk.
Replenishment of front wheel brake fluid
1.Loosen the screws and remove the master cylinder
cover.
2.Wipe clean foreign materials, dirt around the
reservoir, be careful not to let foreign materials fall
into the reservoir.
3.Remove the diaphragm plate and the diaphragm.
4.Add brake fluid to upper level.
5.Install the diaphragm plate and the diaphragm, and
install the master cylinder cover.
6.Please note the diaphragm direction, and do not let
foreign materials fall into the reservoir. And
tighten the master cylinder cover securely.
CAUTION:
 To prevent chemical reaction, please do not use brake fluids other than those recommended.
 Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or plastic
components to prevent damage.
Checking oil quantity in brake oil reservoir
 Park the scooter on a level ground, and check
if fluid level is under the "LOWER" mark.
Recommended Brake Fluid: WELL RUN
BRAKE OIL (DOT 3).
Brake caliper
Brake pad wear
limit grooves
Brake disk
cylinder cover
16
Screw
Master
Diaphragm
Upper
Brake fluid