Electrical Wiring - Riello G3MC Installation, Use And Maintenance Instructions

ELECTRICAL WIRING

NOTES:
– Do not exchange the neutral with the phase.
2
– Wires of min. 1 mm
standards and legislation).
– The electrical wiring carried out by the installer must be in compliance
with the rules in force in the Country.
CONTROL BOX, (see fig. 4)
To remove the control box (1) from the burner:
® Unscrew the fissing screws on the burner cover and remove it.
® Unscrew the fissing screws (2) on the plate and remove the control
box (1).
® Screw the two fissing screws (2) and reassemble the burner cover.
® Fix the control box (1) with plate far from the burner.
TESTING
Check the shut-down of the burner by opening the thermostats.
20013749
section. (Unless requested otherwise by local
Key to lay-out
A
C
E
F
FR - P.E. Cell
H
I
M
PE - Burner-earth
TL
TS
XP.. - Pin plug
Y
Fig. 4
D4677
4 GB
- Control box 530SE
- Capacitor
- Electrode
- Fuse
- Lock-out signal
- Main switch
- Motor
- Limit thermostat
- Safety thermostat
- Oil valve
1 2