Connecting The Hardware - THOMSON SpeedTouch 580 Installation And Setup Manual

2.2 Connecting the Hardware

Wiring
E-DOC-CTC-20050126-0005 v1.0
The figure below shows all possible types of connection to your SpeedTouch™.
15VAC ON/OFF
The colour coded printing on the backpanel of your SpeedTouch™ will
facilitate matching the colour coded cables.
Use the grey DSL cable to wire the SpeedTouch™ DSL port to your telephone
1
wall outlet or distributed filter.
Plug in the coaxial jack from the electric power supply adapter into the
2
SpeedTouch™ '15VAC' port and the other end to the wall outlet.
During the SpeedTouch™ Home Install Wizard, you will be asked to make one of
3
following connections:
Connect the yellow RJ-45 Ethernet cable to the yellow Ethernet port and
the other end to the PC's Ethernet port.
Connect the blue USB cable to the blue USB port on your SpeedTouch™
and the other end to the PC's USB port.
For wireless networking, plug the provided SpeedTouch™110g/120g/121g
or other wireless card or adapter in your computer.
If you will run the SpeedTouch™ Home Install Wizard, as described in
"3.1 SpeedTouch™ Home Install Wizard" on page
recommended to wait to make these connections until the wizard will
ask you to do so.
1 2 3 4
16, it is
Chapter 2
Basic Installation
11