Lite Source LS-80910 Quick Start Manual

ITEM NO.:LS-80910
VERY IMPORTANT
PLEASE READ THOROUGHLY. MAKE SURE YOU PROPERLY ALIGN POLES BEFORE YOU START TO
SCREW THEM TOGETHER. TO AVOID DAMAGING CONNECTION THREADS. NOT ADHERING TO THIS
PROCEDURE MAY VOID YOUR WARRANTY!
INSTRUCTIONS PERTAINING TO A RISK OF FIRE. ELECTRIC SHOCK EXPOSURE TO EXCESSIVE UV
RADIATION OR INJURY TO PERSONS.
IMPORTANT SAFETY INSTRUCTIONS LIGHTED LAMP IS HOT!
WARNING-TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV
RADIATION, OR INJURY TO PERSONS:
 Turn off/unplug and allow to cool before replacing bulb.
 Bulb gets HOT quickly! Only contact switch/plug when turning on.
 Do not touch hot lens, guard or enclosure.
 Do not stay in light of skin feels warm.
 Do not look directly at lit bulb.
 Keep lamp away from materials that may burn.
 Use only with a 180W or smaller lamp.
 Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb.
 Do not operate the lamp with a missing a damaged guard, lamp containment barrier or UV light filter!
BULB INSTALLATION/REPLACEMENT
Important: Always unplug the power cord before installing or replacing bulb and before cleaning or other
maintenance.
1. If shield is pre-installed, then loosen spring (loosen screw on both slips) and remove the bent glass shield.
2. Remove bulb from box, DO NOT remove the protective wrapping or touch bulb with bare fingers at any time.
Expose the ends of the bulb and gently place one end then the other into fixture. Be sure that both ends of bulb
are touching metal contacts. NOW REMOVE WRAPPING
3. Place bent tempered glass over the bulb and then attach with set screws provided. Tighten shield well.
4. Repeat above steps when relamping.