Philips SpeedPro FC6727 Manual page 22

Hide thumbs Also See for SpeedPro FC6727:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
English
12
Problem
The appliance does not
move smoothly across the
floor when cleaning a
carpet.
The brush does not turn
anymore.
FC6727, FC6726, FC6725,
FC6723: The LEDs in the
nozzle do not come on.
The appliance is not
charging.
FC6727, FC6726: The mini
turbo brush does not
function properly.
Possible cause
If dust falls out of the dust
container, the dust container
lid is probably not attached
properly to the dust
container.
You selected a too high
suction power.
The brush encounters too
much resistance.
The brush may stop turning
when it encounters too much
resistance from high-pile
carpet.
You have not installed the
roller brush in the nozzle
properly after cleaning.
You have not attached the
nozzle to the appliance or
handheld properly.
The magnetic connector is
not connected correctly to
the charging disk or the
adapter is not inserted into
the wall socket properly.
You have not connected the
correct adapter and cord.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
Solution
Empty the dust container and attach the
dust container lid correctly.
Reduce the suction power by choosing
setting 1.
Clean the brush with a pair of scissors or
by hand.
Switch off the appliance and then switch
it back on again.
Follow the instructions in the cleaning
chapter of the user manual to slide the
roller brush into the nozzle properly and
secure it inside the nozzle by snapping
home the locking lever.
Attach the nozzle to the appliance or
handheld properly.
Make sure that the magnetic connector
is connected properly to the charging
disk and that the adapter is inserted into
the wall socket properly.
Make sure that you use the correct
adapter and cord.
If you have checked the above and the
appliance still does not charge, take it to
a Philips service center or contact the
Consumer Care Center via
www.philips.com/support.
Remove hairs from the brush with a pair
of scissors (see user manual).
Keep the mini turbo brush aligned with
the surface and do not push the turbo
brush into soft surfaces.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents