Panasonic MGA-ML4TWPoE++ Installation Manual page 4

 When installing this device with the separately sold rubber feet (built-in
magnets) (PN71054), do not install it in places where there are lots of
vibrations and shocks, nor in unstable places, nor in places where people will
pass underneath the device (high places).
Doing so might cause it to fall, which may cause injuries and/or equipment failure.
 Do not look at the laser beam.
Doing so might cause eyesight impairment. (Class 1 laser product)
 Do not put the Ethernet Switch into fire.
Deviation could lead to explosion and/or fire.
 Do not connect the console ports with any other console cables except for our
optional PN72001 RJ45-DSub 9-pin console cable.
Deviation could lead to fire, electrical shock, and/or equipment failure.
 Do not use the Ethernet Switch in dusty environments such as on floors,
underneath floors, the backside of ceilings, or wiring panels.
Do not use the Ethernet Switch in very dusty areas such as on floors, underneath
floors, the backside of ceilings, or wiring panels. Deviation could lead to fire,
electrical shock, and/or equipment failure. It is recommended that the Ethernet
Switch be operated in environments such as the inside of racks where it is difficult
for dust to be generated.
 Use the bundled power cord (AC 100 – 240 V specifications).
Deviation could lead to electric shock, malfunction, and/or equipment failure.
 Unplug the power cord in case of equipment failure.
Deviation, such as keep connecting for a long time, could lead to fire.
 Be sure to connect the ground cable.
Otherwise this might cause electrical shocks, misoperations and malfunctions.
Connect the Ethernet Switch via the supplied power cord to the outlet which is
connected to the ground.
If the outlet is not connected to a ground, connect the ground cable to the ground
terminal screw.
 Connect the power cord firmly to the power port.
Otherwise this might cause electrical shocks and malfunctions.
 Unplug the power cord if the STATUS/ECO LED (Status/ECO mode) blinks in
orange (system fault).
Deviation, such as keep connecting for a long time, could lead to fire.
 Handle the Ethernet Switch carefully so that fingers or hands may not be
damaged by twisted pair port, SFP+ extension slot, console port, or power cord
hook block.
 When mounting the Ethernet Switch on a wall, mount it securely using wall
mount brackets to prevent the Ethernet Switch from falling due its weight and
that of the connection cables.
Deviation could lead to falling, injury and/or equipment failure.
4
WARNING
CAUTION