Table of Contents
Advertisement
2
Part Names and Functions
Table1. Ports and Port LED lamps 1 to 6 correspond as shown below.
Port LED
STATUS/ECO
10G
Communication LED
(Left)
5G
2.5G
1G
LOOP HISTORY
PoE LED
(Right)
14
Display mode
Behavior
Green Light
Green Blink
Orange Light
Orange Blink It is sending and receiving just the
Off
Green Light
Off
Green Light
Off
Green Light
Off
Green Light
Off
Green Light
Off
Green Light
Orange Blink
Off
Communication LED (Left)
PoE LED (Right)
Description
Link is established.
Transmitting and receiving data.
It is shut off via the loop detection
and shutoff function/storm control or
the BPDU guard.
control packet.
No device connected or the ECO mode is set.
Link is established at 10 Gbps.
Link is established at 5 Gbps, 2.5 Gbps, 1000 Mbps
or 100 Mbps, or no device is connected.
Link is established at 5 Gbps.
Link is established at 10 Gbps, 2.5 Gbps, 1000 Mbps
or 100 Mbps, or no device is connected.
Link is established at 2.5 Gbps.
Link is established at 10 Gbps, 5 Gbps, 1000 Mbps
or 100 Mbps, or no device is connected.
Link is established at 1000 Mbps.
Link is established at 10 Gbps, 5 Gbps, 2.5 Gbps
or 100 Mbps, or no device is connected.
Loop has been detected within the last 3 days.
No loop detection history.
PoE are being supplied power.
Single port overload.
Also, an overload of the Ethernet Switch
occurs, and the ports are displayed
which cannot be supplied power.
Power is not being supplied, or the
PoE receiving equipment are not
connected.
Also, it is set in the ECO mode.
Advertisement
Table of Contents
