Advertisement
AIRFLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the
airflow direction automatically:
Press the SWING button on the panel or remote
control to initiate the Auto swing feature. The
louver willl swing up and down automatically.
After the unit has stopped, it can not be restarted
in the first 3 minutes. This is to protect the unit.
Operation will automatically start after 3 minutes.
POWER MANAGEMENT feature(some models)
Under cooling operation, when the ambient
temperature is lower than the set temperature for
a period of time, the unit will automatically operate its
power management feature. The compressor and fan
motor stop. When the ambient temperature is higher
than the set temperature, the unit will automatically
quit the power management feature.
The compressor and (or) fan motor will run
During heating pump mode, remove the lower drain
plug from the back of the unit, install the drain
connector (5/8" universal female mender) with 3/4"
hose(locally purchased). For models without drain
connector, attach the drain hose to the hole.
Place the open end of the adapter directly over the
drain area in your basement floor.
that there are no kinks that will stop the water flow.
Place the end of the hose into the drain and make sure
the end of the hose is down to let the water flow
smoothly.(See Figs with
with ). When the continuous drain hose is not used,
ensure that the corresponding drain plug and knob
are installed firmly to prevent leakage.
When the water level of the bottom tray reaches a
predetermined level, the unit beeps 8 times and the
digital display area shows "P1" . At this time,
the air conditioning/dehumidification
. Never let it up.(See Figs
Advertisement
