SET UP & USE
OPERATION INSTRUCTIONS
STARTING YOUR NEW REFRIGERATOR
After cleaning your refrigerator thoroughly. Wipe the outside with a soft, dry cloth,
the interior with a clean, moist cloth.
1. Insert the power supply cord into the socket.
2. Turn the thermostat dial to an initial setting of "7" for 15-20 minutes.
NOTE: • As the door gets pressed in during shipping, the gasket may have to be
reset. This is done to prevent the cool refrigerated air from escaping. If there
is a gap between the door gasket and the cabinet, set the gasket by gently
pulling it out of the seal gap.
TEMPERATURE CONTROL
NOTE: • If the refrigerator/freezer has been placed in a horizontal or tilted position for
any period of time, wait 24 hours before plugging the unit in.
• The settings of the temperature control are "0, 1, 2, 3, 4, 5, 6, 7." Adjust the
temperature control to the setting that best suits your needs. The setting of
"4" should be appropriate for home or office use.
• Turning the temperature to "0" position will shut off the cooling cycle in
both the refrigerator and freezer sections, but does not turn off the electrical
power to the unit.
NOTE: • Wait 3-5 minutes before restarting if you unplug the refrigerator. The unit
may fail to operate properly if restarted too quickly.
• If the ambient temperature is too high, the refrigerator may not reach the
desired target temperature.
• Large amounts of food will lower the cooling efficiency of the appliance.
• Do not place food items on the air outlet and leave spaces for airflow.
• If you choose to change the thermostat setting, adjust thermostat control
one increment at a time. Allow several hours for temperature to stabilize
between adjustments.
Page 9