Starting A Journey - HMM Diagnostics smartLAB bike3 User Manual

IV Starting a journey.
The cycle computer is ready for use after the setting. When
you start driving, the computer will start automatically.
The data is collected and displayed. You can reset some values
if you hold down the SET button for more than 2 seconds in
the particular mode.
While driving, the speed is always displayed next to the set
mode.
There are two arrows next to the speedometer.
When the bottom arrow is shown, it means that your current
values are lower than your average.
When the top arrow is shown, it means that your current
values are higher than your average.
When both arrows are shown, it means that your current valu-
esareequaltoyouraverage.
The cycle computer goes into sleep mode when it no longer
receivesanydatafromthesensor.Itwakesupwithevery
movement and when receiving data from the sensor, the speed
is displayed.
Betweenthetimeof5:00p.m.and7:00a.m.,thebackground
lightingwillcomeonfor5secondswhenanykeyispressed.