Rangemaster U110120 - 01A Installation And User Manual page 10

fig.4-2 Cabinet hinge screws
fig.4-3
Cover caps
fig.4-4
Procedure
1.
Loosen the cabinet hinge screws and carefully slide
the door off (fig.4-2). To stop the door from being
damaged, place it on a cushioned surface.
2.
Lever off the cover caps on the left-hand side of the
appliance cabinet (fig.4-3).
3.
Remove the door hinge screws and refit to the left-
hand side of the cabinet. These screws should only be
partially tightened.
4.
Undo the door hinge screws and remove the hinges.
5.
Reverse the position of the top and bottom hinges
and fit them to the left-hand side of the door (fig.4-4).
Secure in place using the door hinge screws.
6.
Slide the door onto cabinet hinge screws. Tighten the
screws to secure.
7.
Insert the cover caps into the holes on the right-hand
side of the cabinet.
IMPortant: After you have completed reversing the door,
check that the door opens and shuts correctly without
fouling.
You should also check the door seal of the appliance. The seal
should not be creased or crushed; otherwise there will be a
gap between it and the inside of the door.
The seal must adhere properly all the way around the door.
If the seal is not adhering to the cabinet properly, then you
should either:
A.
Use a warm damp cloth and manipulate the seal until it
does adhere to the cabinet properly, all the way around
the door, or
B.
Use a hair dryer on its lowest heat setting and lightly
heat the areas of the door seal that are not adhering
correctly. The heat will make the seal more pliable
and this will allow you to manipulate the seal into the
correct position.
IMPortant: DO NOT heat the door seal on anything but
the lowest heat setting or heat the seal for a long period
of time, otherwise you may damage the door seal, which
would NOT be repaired under the guarantee free of charge.
The appliance must be stood on a level floor. You can use the
levelling feet to take into account any minor unevenness in
the floor.
8