Advertisement
Commissioning
•
Plug the plug of the pipe cleaner into a suitable socket. Make sure that the switch is in the "OFF"
position (fig. 1, commissioning).
•
To loosen the clog, use only the small diameter drill and first drill the clogging.
•
If the clogging is open and the water drains slowly, use the largest adapted drill to completely
drill the clogging. If the blockage is removed, a thorough rinse is recommended. If present, the
pipe wall should be cleaned with a chain spinning drill with running water.
•
Depending on the clogging, different tools can be attached to the spiral. Select a suitable at-
tachment and attach it to the spiral. Make sure that the attachment is securely engaged in the
holder. The attachment can only be removed with the help of a screwdriver.
•
The attachment may only be changed if the spiral is not in the device. To release the spiral, the
lateral lever must be in pos. 4a. You can now simply pull the spiral out of the device.
•
To be able to use the pipe cleaning device, the white plastic sleeve must be inserted correctly.
Please check the seat of the sleeve before each use (2). Make sure that the lever is in pos. 4a,
and push the spiral through the device until the drill comes out of the device at the front.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Commissioning
Item 51451
Page 6
03
2022-1
Advertisement
