Maintenance; Specification - HOGERT HT8G616 User Manual

Note: Monitor the ammeter regularly so that you can turn off the charger as soon as the battery is fully charged. When charging very
cold batteries, the initial charging speed may increase as the battery warms up. Do not try to charge a frozen battery. Internally da-
maged (short-circuited) batteries will draw very high current without charging. If the battery has been charged for 5-10 minutes and
it does not show any drop in charging current, the battery may be damaged. Discontinue charging and have a professional battery test
performed
Disconnect the negative terminal (black)
Disconnect the positive clamp (red)
Insert the battery into the vehicle if it was removed ensuring that the positive pole is connected before the negative pole.
IMPORTANT: disconnect the battery charger from the mains supply, then disconnect the battery. Leaving the battery connected may
cause overcharging and permanent damage of the battery.

MAINTENANCE

WARNING: Always make sure that the charger is disconnected from the mains supply before performing any maintenance procedure.
1. Cleaning - keep the device clean. Do not let debris build up on any part of the device.
Always remove dust and particles and never let the vents be blocked as it will prevent the charger from cooling. Use a soft brush, dry
cloth or vacuum cleaner to clean the device.
2. Storage
Store this device carefully in a safe, dry place and away from children

SPECIFICATION

Input voltage
Charging power
Maximum charging power
Battery capacity range
Battery type
Charging voltage
Thermal protection
IP rating
Length of the charging cable
Length of the power supply cable
Dimensions (L x W x H)
Product weight
Electrical diagram
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków, www.hoegert.com
230 / 50Hz
14A
26A
40-350Ah
Lead-acid
12V/24V
30A, 5A
IP20
1 m
1.5 m
61x33.5x23.5cm
15.6 kg
7