Casio EXILIM EX-Z77 User Manual page 74

■
Changing the Flash Intensity
1.
In the REC mode, press [MENU].
2.
On the "Quality" tab, select "Flash Intensity"
and then press [ ].
3.
Use [ ] and [ ] to select the flash intensity
setting you want and then press [SET].
You can set one of five levels, from –2 (weakest) to +2
(strongest).
IMPORTANT!
• Flash intensity may not change when the subject is too far
away or too close.
■
Using Flash Assist
The subject in an image will look too dark if flash intensity is not
enough to reach a subject that is too far away. When this
happens, you can use flash assist to supplement the brightness
of the subject so it appears as if flash illumination was sufficient.
Flash assist not used
Flash assist is turned on as the initial factory default setting.
Use the following procedure to turn off flash assist when you do
not want to use it.
74
Flash assist used
SHOOTING A SNAPSHOT