Page 1
BH1OZ2000 www.bahco.com.au Consult the vehicles manufacturer’s manual prior to lifting the vehicle. Conduct a pre-operational check of the equipment. AS 2615:2016 ORIGINAL INSTRUCTIONS BH1OZ2000 Rev. 012219...
Page 2
• Chock the unlifted wheels of the vehicle. • No person should remain in a vehicle that is being lifted. • Center load on saddle. Be sure setup is stable before working on vehicle. SAVE THESE INSTRUCTIONS BH1OZ2000 Rev. 012219...
2. Lubricate all linkages and pivot points. (Use white lithium spray grease only.) 3. Remove handle; lubricate handle receptacle and handle end. (Use white lithium spray grease only.) 4. Lubricate both rear casters, bearing and both front wheels. (Use white lithium spray grease only.) 5. Tighten all accessible hardware. BH1OZ2000 Rev. 012219...
GHES450 Handle Assembly 1. Connect the two short handles together and tighten by screws and nuts. 2. Plug the handle into the jack. 3. Tighten the locking screw. BH1OZ2000 Rev. 012219...
Lift vehicle 1. Clockwise turn the handle to 2. Pumping the handle up and down to lift completely close the release valve. the vehicle. Lower vehicle 3. Counter-clockwise and slowly rotate the handle to lower the vehicle. BH1OZ2000 Rev. 012219...
GHES450 Refilling oil Remove the tool tray. Remove the oil sealing screw from the pump. ISO VG 15 Refill till oil level is visible. OIL VOLUME(ml) BH1OZ2000 BH1OZ2000 Rev. 012219...
Page 10
GHES450 DECLARATION OF CONFORMITY Reference: BH1OZ2000 Type: Jack Year: 2019 Was manufactured in conformity with the provisions in the: AS 2615:2016 Quality manager / Signature: SNA E Australia PO Box 98, Hoxton Park, NSW 2171 Australia BH1OZ2000 Rev. 012219...