Table of Contents
Advertisement
The following will guide you through the installation of your P50i printer.
13
1 • 3
Printer Installation
CAUTION:
current draw to 16 amps or less, using an associated circuit breaker or other such
device. Never operate the printer in a location where operator, computer, or
printer can get wet. Personal injury could result. The printer must be connected
to an earthed electrical power supply and properly protected against electrical
surges and grounding faults. The power supply pack can only be
replaced by the same product from the constructor.
1 •
Place the printer in a location that allows easy access to all sides. The printer
should never be operated while resting on its side or upside down.
2 •
Place the printer's power switch in the OFF "O" position.
3 •
Insert the power supply to the printer power socket "1" and attach to grounded
electrical socket of the proper voltage and type.
4 •
Attach interface cable "2" to printer and computer and then secure.
5 •
Switch power on.
CAUTION:
connectors. If damaged, the power cable must be replaced by an exact
equivalent. Use only Parallel Cable under 3 Meters in length.
The socket should always be easily accessible to power off the printer.
Limit AC power supplied to the P50i Printer to 24 VDC. Limit excess
Intermittent or unpredictable operation may occur from unsecured
Advertisement
Table of Contents
