Table of Contents
Advertisement
LT2510
Wireless Module
CONFIGURING
THE LT2510
30 www.lairdtech.com
COMMAND DESCRIPTIONS
Write IRAM
This command is used to change the IRAM contents.
The IRAM contains the active (in memory) copy of
the EEPROM parameters. Some of these fields are
available for reading and writing to provide on-the-
fly instantaneous setting of parameters. Parameters
changed via the IRAM commands will take effect
immediately and will remain in effect until the radio is
reset. IRAM changes do not persist after a reboot.
Restrictions on the specific IRAM parameters are the
same as for the EEPROM parameters.
Available locations in IRAM are:
Name
Range Refresh
RF Channel
Interface Timeout
RF Packet Size
CTS_On_H
CTS_On_L
CTS_Off_H
CTS_Off_L
Max Power
Destination MAC Address 3
Destination MAC Address 2
Destination MAC Address 1
Destination MAC Address 0
System ID
Write Destination Address
The OEM Host issues this command to the transceiver to
change the Destination Address.
Read Destination Address
The OEM Host issues this command to the transceiver to
read the Destination Address.
Auto Destination/Channel
The Host issues this command to change the Auto
Destination setting. When issuing this command, the
Auto Destination setting will only be changed if the
corresponding enable bit is set. Otherwise, the command
performs a read of Auto Destination. If both Broadcast
Mode and Auto Destination are enabled, the radio will
send the RF packets in Broadcast Mode.
Command:
Number of Bytes Returned:
Response:
Parameter Range:
<Location>:
<Value>:
Address
0x3D
0x41
0x58
0x5A
0x5C
0x5D
0x5E
0x5F
0x63
0x72
0x73
0x74
0x75
0x76
Command:
Number of Bytes Returned:
Response:
Parameter Range:
0x00 - 0xFF corresponding to the 3 LSBs of the
destination MAC Address. MAC3 is the LSB.
Command:
Number of Bytes Returned:
Response:
Parameter Range:
0x00 - 0xFF corresponding to the 3 LSBs of the
destination MAC Address. MAC3 is the LSB.
Command:
Number of Bytes Returned:
Response:
Parameter Range:
<Auto Dest> = bit 7: Ignored
<0xCC> <0x0B> <Location> <Value>
3
<0xCC> <Location> <Value>
[Dependant of parameter]
0x00-0xFF
<0xCC> <0x10> <MAC1> <MAC2>
<MAC3>
4
<0xCC> <MAC1> <MAC2i> <MAC3>
<0xCC> <0x11>
4
<0xCC> <MAC1> <MAC2> <MAC3>
<0xCC> <0x15> <Data>
2
<0xCC> <Auto Dest>
bit 6: Ignored
bit 5: Enable Modification of Auto
Channel
bit 4: Enable Modification of Auto
Destination
bit 3: Ignored
bit 2: Ignored
bit 1: Auto Channel
bit 0: Auto Destination
Laird Technologies
Advertisement
Table of Contents
