Table of Contents
Advertisement
a. Install RR.(rear) Shocks and tighten the nuts.
b. Install Ball Head, Tie Rod, tighten the Castle Nut and insert the cotter Pin,
c. Install Dust Seals, align the Ball Head Bolt, Knuckle Support to the square hole on
the Lower A-Arm.
d. Install Flange Nut and tighten it (>88.9 foot lbs).
e. Install Front Tires and tighten the nuts.
f. Install Rear Tires, tighten the nuts, insert cotter Pin and put on the Rubber Cover.
g. Raise the C.B.C. bar as the picture shows.
h. Install C.B.C. bar RR., put on R-Washer.
i. Install Head-Rest.
j. Check all nuts and bolts, wiring, cables, fuel line, switches, and tire pressure.
k. Fill battery with Acid and charge, check and fill the engine with the recommended
oil. Replace and dispose the original packing/shipping oil that came in the engine
in an appropriate container.
l. Fill fuel tank with Unleaded Gasoline, and turn on the ignition switch to start the
engine.
!
Advertisement
Table of Contents
