Advertisement
LAKE ADELA RECTANGLE WOVEN
DINING TABLE
HDC#: 1928810829 MFG#: FRA60408AS-ST-CH
Please read over this instruction manual as it will save time in the
assembly of this product.
Note: Prior to assembly, please open and lay parts out on a clean, soft
flat surface to avoid any damages to the product's finish.
Advertisement
Table of Contents
Related Manuals for Home Decorators Collection Lake Adela
Summary of Contents for Home Decorators Collection Lake Adela
- Page 1 LAKE ADELA RECTANGLE WOVEN DINING TABLE HDC#: 1928810829 MFG#: FRA60408AS-ST-CH Please read over this instruction manual as it will save time in the assembly of this product. Note: Prior to assembly, please open and lay parts out on a clean, soft...
- Page 2 Caution: The Lake Adela Dining table was made for the explicit purpose of providing outdoor functions and is not to be used as a toy. This product is not intended for inclement /severe weather in any form including, but not limited to: rain, hail, sleet, snow and/or wind. Manufacturer recommends that with formidable weather approaching you store and/or cover this dining table.
- Page 3 DO NOT RETURN TO RETAILER IF YOU HAVE ANY QUESTIONS OR CONCERNS PLEASE VISIT OUR WEBSITE AT: www.yotrioint.com OR TOLL FREE AT: 1-800-245-2217 MONDAY-FRIDAY 8:30 AM TO 5:00 PM PACIFIC STANDARD TIME / 11:30 AM TO 8:00PM EASTERN STANDARD TIME Warranty Coverage Requirements: 1.
- Page 4 Parts Check List Please remove all parts carefully from box and lay out on clean, soft surface to protect product’s finish. ① ② Table Leg - 4PCS Table Top – 1PC ③ ④ Short Skirt - 2PCS Long Skirt – 2PCS...
- Page 5 B. M6X25 Bolt – 16PCS A. M6X15 Bolt – 16PCS C. M6 Washer – 32PCS D. Hex Wrench – 1PC...
- Page 6 Attach the table leg (2) to the long skirt (4) and short skirt (3) using M6x25 bolts (B) and M6 washer (C). Use the hex wrench (D) to loosely tighten all the bolts. Repeat this step for the other table legs. Do not fully tighten all the bolts!
- Page 7 Lay the table top (1) upside down on a soft surface. Connect the table leg (2) to the table top (1) using M6x15 bolts (A) and M6 washers (C). Use the hex wrench (D) to loosely tighten all the bolts. Repeat this step for the other table legs. Do not fully tighten the bolts!
- Page 8 Once all the bolts are in place. Fully tighten all the bolts with the hex wrench (D). Turn the table right side up. Check to ensure the table is tightly assembled and stable before use.
Need help?
Do you have a question about the Lake Adela and is the answer not in the manual?
Questions and answers