Related Manuals for GDS SHARK
Summary of Contents for GDS SHARK
- Page 1 Commissioning // Instruction manual SHARK 5-Jaw Chuck for Walter machines grinding deserves SOLUTIONS...
- Page 2 SHARK 5-Jaw Chuck SHARK 5-Jaw Chuck interference contour Case includes: SHARK 5-Jaw Chuck for a clamping range of 3-20 mm. 110,4 SHARK 5-Jaw Chuck Available for the following machines: SHARK adapter flange tension rod ANCA Rohabmessung: Gewicht (kg): 6.70 Allgemein-...
- Page 3 Commissioning SHARK 5-Jaw Chuck ATTENTION: Step 1: Preparation of the adapter flange The SHARK 5-Jaw Chuck is only suitable for automatic operation. Make sure that the face of the machine interface is level and clean. Dial gauge Clean all contact surfaces of the adapter flange.
- Page 4 For shank tools, all shanks according to DIN 1835 Form A, B, E or DIN 6535 form HA, HB, HE can be clamped. • The SHARK multi-range clamping system may only be used within the scope of its technical Step 5: Adjust concentricity data.
-
Page 5: General Safety Instructions
Do not reach between the clamping jaws. For hand-loaded machines, the tool feed must be carried out via a setting aid. Danger to persons (risk of injury) and damage to property can arise from the SHARK multigrip clamping system if: •... - Page 6 SHARK basic safety instructions SHARK Aufbau Note for safe operation Structure of the 5-jaw chuck • Cylindrical tools with an outer diameter of at least 3 mm can be clamped as the smallest tool. If The 5-jaw chuck and the associated actuating device must be matched to each other. The stroke of smaller tools are clamped, they cannot be clamped safely.
- Page 7 GDS Präzisionszerspanungs GmbH // Endelbergstraße 8 // 72131 Ofterdingen Telefon: + 49 (0) 74 73 - 27 26 72 E-Mail: info@gds-praezision.de Telefax: + 49 (0) 74 73 - 27 26 49 Web: www.gds-praezision.de...