Page 1
Assembly instructions // Instruction manual SHARK 5-Jaw Chuck for ANCA machines grinding deserves SOLUTIONS...
Page 2
SHARK 5-Jaw Chuck ANCA SHARK 5-Jaw Chuck ANCA interference contour Case includes: SHARK 5-Jaw Chuck for a clamping range of 3-20 mm. 110,4 SHARK 5-Jaw Chuck Available for the following machines: SHARK adapter flange tension rod ANCA Rohabmessung: Gewicht (kg): 6.70...
Page 3
SHARK 5-Jaw Chuck ANCA Machine ATTENTION: Step 1: Screw in tension rod spindle The SHARK 5-Jaw Chuck is only Tension rod suitable for automatic operation. Screw the tension rod into the machine spindle using the supplied double-ended socket wrench (11).
Page 4
For shank tools, all shanks according to DIN 1835 Form A, B, E or DIN 6535 form HA, HB, HE can be clamped. • The SHARK multi-range clamping system may only be used within the scope of its technical ATTENTION: data. within the scope of its technical data.
During manual loading and unloading, there is a risk of crushing limbs due to ope- Danger to persons (risk of injury) and damage to property can arise from the SHARK 5-Jaw Chuck ning and closing of the clamping jaws. Do not reach between the clamping jaws. For system if: hand-loaded machines, the tool feed must be carried out via a setting aid.
Page 6
SHARK ANCA basic safety instructions SHARK ANCA Set up Note for safe operation Mounting the 5-jaw chuck The 5-jaw chuck and the associated actuating device must be matched to each other. The stroke of • Cylindrical tools with an outer diameter of at least 3 mm can be clamped as the smallest tool. If the chuck must be sufficient to safely accommodate the largest and smallest diameter to be clamped.