Sony HCD-SPZ90DAB Service Manual page 19

• Note For Printed Wiring Boards and Schematic Diagrams
Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• f : internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Indication of transistor
C
Q These are omitted.
B E
Q
B C E
These are omitted.
HCD-SPZ90DAB
Note on Schematic Diagram:
• All capacitors are in μF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• f
: internal component.
• 2 : nonflammable resistor.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
– CD Board –
no mark :CD PLAY
– Other Boards –
no mark : TUNER (DAB/FM)
( ) : CD PLAY
〈〈 〉〉 : TAPE PLAY
{ } : TAPE REC
∗ : Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : TUNER (DAB/FM)
J : CD PLAY
d : TAPE PLAY
G : REC
f : AUDIO IN
• Circuit Boards Location • Circuit Boards Location
POWER board
FL board
PANEL board
HP A-IN board
19 19
HCD-SPZ90DAB
MAIN board
SP board
AMP board
TC board
ANTENNA board
DAB module
DAB board
CD board