Speaker Distance; The Input Assign Menu - Pioneer VSX 920 Operating Instructions Manual

06 The System Setup menu
Tip
• You can change the channel levels at any
time by press
SELECT and LEV +/– on the remote control.
You can also press CH SELECT and use /
 to select the channel, and then use /
 to adjust the channel levels.

Speaker Distance

For good sound depth and separation from
your system, you need to specify the distance
of your speakers from the listening position.
The receiver can then add the proper delay
needed for effective surround sound.
1 Select 'Speaker Distance' from the
Manual SP Setup menu.
2.Manual SP Setup
a.Speaker Setting
b.Crossover Network
c.Channel Level
d.Speaker Distance
2 Adjust the distance of each speaker
using /.
You can adjust the distance of each speaker in
0.1 feet increments.
3 When you're finished, press RETURN.
You return to the Manual SP Setup menu.
48
En
RECEIVER
, then press CH
2d.Speaker Distance
10.0 ft
Front L
Center [ 10.0 ft
Front R [ 10.0 tt
Surround R [ 10.0 ft
Surr. Back R [ ––––
Surr. Back L [ ––––
Surround L
[ 10.0 ft
Subwoofer [ 10.0 ft
Return
Return

The Input Assign menu

You only need to make settings in the Input
Assign menu if you didn't hook up your
equipment according to the default settings for
the component video inputs.
• Default settings:
Component 1 – BD
Component 2 – DVD
Important
• If you connect any source component to
the receiver using a component video
input, you should have your TV connected
to this receiver's COMPONENT VIDEO
OUT or HDMI OUT output (down
converting component video is not
possible after assigning an input).
]
If you didn't make component video
]
]
connections according to the defaults above,
]
]
]
you must assign the numbered input to the
]
component you've connected (or else you may
see the video signal of a different component).
For more on this, see Using the component
video jacks on page 28.
1 Press
RECEIVER
then press the SETUP button.
An on-screen display (OSD) appears on your
TV. Use /// and ENTER on the remote
control to navigate through the screens and
select menu items. Press RETURN to confirm
and exit the current menu.
on the remote control,
System Setup
1.Auto MCACC
2.Manual SP Setup
3.Input Assign
4.Speaker System
5.Video Parameter
Return