Shop-Vac SH Series User Manual page 6

FIGURE 2
Assemble as follows:
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that the
bottom is facing up.
FIGURE 3
B
FIGURE 4
B
A
B
B
A
B
FIGURE 5
FIGURE 6
FIGURE 7
3. With tank drain facing you,
take caster feet marked with
the letter A, FIGURE 3, and
place in the slots on left front
and right rear of tank also
marked with the letter A.
4. Secure with screws provided.
FIGURE 4.
5. Take caster feet marked
with the letter B and place on
right front and left rear of tank
also marked with the letter B.
FIGURE 5.
6. Secure with screws provided
FIGURE 6.
7. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place. FIGURE 7.
FIGURE 8
FIGURE 9
10. Return tank to upright position.
TOOL HOLDER
ASSEMBLY
FIGURE 10
FIGURE 11
FIGURE 12
8. With tank drain facing
you, attach hose holder A
to caster foot A, and hose
holder B to caster foot B.
FIGURE 8.
9. Apply pressure to front
of hose holder to snap into
place. FIGURE 9.
11. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 10.
12. Place "J" shaped tabs
into the slots on cord wraps
FIGURE 11. Press down until
tabs snap into place.
13. Press down on center of
tool holder until tab latches on
bottom of lid. FIGURE 12.
PAGE 5