Pioneer DV-120K-K Operating Instructions Manual page 20

Problem
Folder or file names are not dis-
played in alphabetical order.
Much time is required to recognized
the USB device.
Power is not supplied to the USB
device.
Audio CD tracks cannot be recorded
on a USB device.
When connected to an HDMI-compatible device
(DV-220KV-K only)
Problem
Picture is not displayed.
Sound is not produced or is dis-
torted.
Multichannel audio signals are not
output.
Colors are not properly displayed on
TV screen.
20
En
Check
This is not a problem with the player.
What is the USB device's capacity?
Is Err displayed on the front panel dis-
play? No power is supplied if the power
consumption is too high.
Is there enough free space on the USB
device?
Are there 300 or more folders on the
USB device?
Are there already 99 PIONEER folders
on the USB device?
Check
Is the resolution properly set?
Is the HDMI cable properly connected?
Is HDMI Out properly set?
Is HDMI Out properly set?
Is HDMI Color properly set?
Remedy
The order of the folder and file names displayed
on the Disc Navigator depends on the order in
which the folders or files were recorded on the USB
device.
Some time may be required to load the data when
large capacity USB devices are connected (this
could take several minutes).
Turn the power off then back on.
Turn the power off, then disconnect and reconnect
the USB device.
Press DVD/ USB to switch back to the DVD mode,
then switch again to the USB mode. (When the
input is switched back to the DVD mode, LOAd is
displayed on the front panel display and the disc
is recognized. When the input is switched back
to USB, USb is displayed on the front panel display.)
If the USB device is equipped with an AC adapter,
use the USB device with the AC adapter connected.
Recording is not possible if there is not enough free
space left on the USB device. In this case, Available
USB space is low is displayed.
Recording is not possible if the USB device con-
tains 300 or more folders.
Recording is not possible if there are already 99
PIONEER folders on the USB device.
Remedy
Set HDMI Resolution properly for the connected
device (page 15).
Restore HDMI Resolution to the default setting
(720x480p/ 720x576p) (page 15).
Connect the cable securely (all the way in).
With some cables, 1 080p video signals will not be
output.
Set HDMI Out to LPCM (2CH) or Auto (page 14).
Set HDMI Out to Auto (page 14).
Change the HDMI Color setting (page 15).