Table of Contents
Advertisement
en Troubleshooting
Fault
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray.
Excessive formation of
foam occurs.
Fault
Special salt refill indic-
ator lights up.
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
42
Cause and troubleshooting
Only add detergent to a detergent dispenser when
▶
dry.
Hand washing-up liquid is present in dispenser for
rinse aid.
Immediately add rinse aid to the dispenser.
▶
→ "Adding rinse aid", Page 23
Rinse aid has been spilled.
Remove the rinse aid with a cloth.
▶
Detergent or appliance care product used causes ex-
cessive foaming.
Change the brand of detergent.
▶
Cause and troubleshooting
Insufficient special salt.
Add Special salt → Page 21.
▶
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Water softening system is switched off.
Setting the water softening system → Page 21
▶
Insufficient rinse aid.
Add Rinse aid → Page 23.
1.
Set the amount of rinse aid to be dispensed.
2.
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
→ "Setting the amount of rinse aid", Page 23
→ "Setting the amount of rinse aid", Page 23
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 32.
1.
Clean the Wastewater pump → Page 45.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 30
▶
Advertisement
Table of Contents
